POOL LIGHT IPP “SUPREME” LED RETROFIT COLOUR CHANGING WHITE FACE

Supreme series color LED 50ft: 100 ft underwater swimming pool light

12 volt
easy to install
sealed unit
approved cable for much easier installation
5 vibrant color schemes to choose from
30 000 hours guaranteed
1-year warranty
matching spa light available
fits into most popular swimming pool light existing niche’s as a retrofit up to 6 lights can be synchronized
uses only 16 watts lowest in the market-saving energy use by 95%

Traditionally swimming pools used incandescent lights. Thankfully 12v LED lights are available, the leap in technology has resulted in dramatic change.

By far the biggest benefit is safety. Traditional lights pose a huge safety risk in water that transmits power if not installed properly. By contrast, 12v LED lights installed by a qualified pool installer or electrician pose a minimum threat.

The next huge benefit over the incandescent lights is the cost to run. Consumers and governments are striving to “go green” and led lights to offer this as a solution.

Ipp supreme series lights are arguably the most energy-efficient underwater lights in the market using only 16 watts. Compare this to an average use incandescent or halogen light that consumes a whopping 160 + watts. IPP can brag a massive 90% saving.

On traditional lights, IPP compares 16 watts to around 46 watts.

With regard to durability, the ipp white lights life span is 50 000 hours plus, the incandescent only around 5 000.

IPP supreme series lights are sealed units. The 2 wire UL approved cable is much thinner and easier to install in old and new conduits and tight corners.

IPP underwater lights are, much safer than incandescent in the pool, much more attractive, much cheaper to run, far easier to install, UL approved, does not need bonding, last ten times longer. These lights can also burn out of the water without blowing the led’s unlike most other lights in the market.

Installation is easy:http://www.integratedpoolproducts.co.za/supreme-led-lighting.html#supreme-videos

It is not necessary to drain a pool’s water to replace pool lights (globes)

Tip:

If your concrete or fibreglass moulded have an Quality pool light housing, the hole is about 2mm smaller than the LED replacement light. To make it fit; use a knife to trim the plastic or use sanding paper to reduce the thickness of the ribs in order to fit into the housing.
Warning:

Do not connect pool lights to 220V. Consult or hire a electrician to fit lights if you’re in doubt or WHATSAPP 064 534 4691
Your pool DB Board and electrical circuit should have a 12 Volt transformer as power source to for underwater pool light(s).

PLEASE NOTE ALL POOL LIGHTS ARE TESTED PRIOR TO LEAVING THE WAREHOUSE ,A WHATSAPP VIDEO IS INCLUDED WITH YOUR PURCHASE AS PROOF OF TEST WITH TIME STAMP .DUE TO THE INSTALLATION NATURE OF PRODUCT LIGHTS CARRY ONLY FACTORY MALFUNCTION WARRANTY AND WILL BE TESTED AFTER PRODUCT IS RETURNED FOR A WARRANTY CLAIM BY FACTORY .WARRANTY CLAIM WILL ONLY BE ENTERTAINED IF A FACTORY FAULT IS DETECTED.ALL POOL LIGHTS CARRY A 6 MONTH FACTORY WARRANTY.INSTALLTION INVOICE WITH ELECTRICIANS DETAILS IS REQUIRED FOR A WARRANTY CLAIM TO BE PROCESSED.http://www.integratedpoolproducts.co.za/warranty-registration.html